WASHlNG (Total cleaning time should not exceed 5min)

1.The reusable alcohol is filtered through a 200 mesh filter bag before each cleaning operation to ensure the

cleanliness of the alcohol.

2.Soak the platform and model together into clean 95% alcohol, set the cleaning machine working time for 2min

and wait for the resin attached to the surface of the model to be rinsed clean.

3.Put the platform and model into clean 95% alcohol again, set the cleaning machine working time for 2min, and

wait for the model to be cleaned.

4.Remove the model from the platform and blow out the alcohol on the surface with compressed air, then leave

it in a cool place until it is completely dry.

CURING

This material in the printing of small parts and no complex details of the model can choose to directly

embedded gypsum into the casting process, if the model surface has more uneven grooves or large pieces ot

the model in order to ensure the casting effect, it is recommended to carry out the post-curing, post-curino

operation process is as follows.

wil be thoroughly dried model placed into the LED-type curing box, curing time of 30min, if you find that the

model has a deformation in the curing process lf the model is found to be deformed during the curing process

then the model can be put into clean water for post-curing operation.